Authors

Nazaruddin Sinaga

Department of Mechanical Engineering, Faculty of Engineering, Diponegoro University, Semarang, Indonesia

Dwi Basuki Wibowo

Department of Mechanical Engineering, Faculty of Engineering, Diponegoro University, Semarang, Indonesia

Rendy Augustino Sam

Department of Mechanical Engineering, Faculty of Engineering, Diponegoro University, Semarang, Indonesia

Abstract

Indonesia holds considerable wind energy potential, yet its prevailing wind speeds of roughly 2–6 m/s make it difficult for conventional turbines to operate near their optimum. Diffuser-augmented (ducted) wind turbines offer a promising remedy by accelerating the flow through the rotor plane. This study uses computational fluid dynamics (CFD) to examine how inlet wind speed, diffuser expansion ratio (ER), and relative flow rate affect the torque, power, and power coefficient of a ducted horizontal-axis wind turbine. Steady-state simulations were performed in ANSYS Fluent with a pressure-based solver, the k–ω SST turbulence model, and the Multiple Reference Frame (MRF) approach. The model was validated against published data at 4.5 m/s, with deviations of about 9.4% in torque and power. Raising the wind speed from 3 to 20 m/s increased the power output from 30.23 W to 139.87 W, while increasing ER from 1.0 to 2.5 raised it from 28.99 W to 35.79 W, with the gains flattening beyond ER = 2.0. Scaling the flow rate from 0.4Q to 1.6Q increased power from 28.06 W to 39.43 W but sharply reduced the power coefficient, revealing a trade-off between power output and conversion efficiency. Because the rotor speed was held constant, the effective tip speed ratio changed across the cases, which largely explains these trends. Within the ranges studied, wind speed was the dominant influence on power output, and a larger expansion ratio further improved energy extraction, supporting the use of diffusers in low-to-moderate wind regimes.

Keywords

Ducted wind turbine diffuser-augmented wind turbine expansion ratio computational fluid dynamics power coefficient wind energy low wind speed

Citation of this Article

Nazaruddin Sinaga, Dwi Basuki Wibowo, & Rendy Augustino Sam. (2026). CFD Investigation of the Effects of Wind Speed and Duct Geometry on the Performance of a Ducted Wind Turbine for Energy Efficiency. Current Journal of Engineering and Science Research. 3(11), 16-25. Article DOI: https://doi.org/10.47001/CJESR/2026.311003 

Licence Copyright (c) 2026 Current Journal of Engineering and Science Research. This work is licensed under a Creative Commons Attribution Non Commercial 4.0 International Licence.

References

  1. Global Wind Energy Council, “Global Wind Report 2025,” GWEC, Brussels, Belgium, Apr. 2025.
  2. P. Sadorsky, “Wind energy for sustainable development: Driving factors and future outlook,” Journal of Cleaner Production, vol. 289, 2021.
  3. C. Jung, “Recent development and future perspective of wind power generation,” Energies, vol. 17, no. 21, 2024.
  4. PT PLN (Persero), Rencana Usaha Penyediaan Tenaga Listrik (RUPTL) 2025–2034, approved by Minister of Energy and Mineral Resources Decree No. 188.K/TL.03/MEM.L/2025. Jakarta, Indonesia, 2025.
  5. N. A. Pambudi et al., “The future of wind power plants in Indonesia: Potential, challenges, and policies,” Sustainability, vol. 17, no. 3, 2025.
  6. T. Burton, D. Sharpe, N. Jenkins, and E. Bossanyi, Wind Energy Handbook, 3rd ed. Chichester, U.K.: Wiley, 2021.
  7. D. A. Teklemariyem, N. H. R. Syed, and P. B. Dao, “CFD-driven design optimization of corrugated-flange diffuser-integrated wind turbines for enhanced performance,” Energies, vol. 18, no. 17, 2025.
  8. N. Shambira, G. Makaka, and P. Mukumba, “Velocity augmentation model for an empty concentrator-diffuser-augmented wind turbine and optimisation of geometrical parameters using surface response methodology,” Sustainability, vol. 16, no. 4, 2024.
  9. N. Bekele and W. Bogale, “Parametric study of a diffuser for horizontal axis wind turbine power augmentation,” AIMS Energy, vol. 7, no. 6, pp. 841–856, 2019.
  10. S. Sridhar et al., “Aerodynamic comparison of slotted and non-slotted diffuser casings for diffuser augmented wind turbines (DAWT),” Renewable and Sustainable Energy Reviews, vol. 161, 2022.
  11. M. A. Rahmatian, P. Hashemi Tari, M. Mojaddam, and S. Majidi, “Numerical and experimental study of the ducted diffuser effect on improving the aerodynamic performance of a micro horizontal axis wind turbine,” Energy, vol. 245, 2022.
  12. I. H. Kim, B. R. Kim, Y. J. Yang, and S. J. Jang, “Parametric study on ducted micro wind energy harvester,” Energies, vol. 15, no. 3, 2022.
  13. A. T. Nile, M. Emam, S. Ookawara, and S. A. Nada, “Performance prediction of a small-scale diffuser-augmented wind turbine with and without an inlet nozzle: A 2D and 3D analysis,” Energy Conversion and Management, vol. 327, 2025.
  14. A. A. Firoozi, F. Hejazi, and A. A. Firoozi, “Advancing wind energy efficiency: A systematic review of aerodynamic optimization in wind turbine blade design,” Energies, vol. 17, no. 12, 2024.
  15. H. Hamid and R. M. Abd El Maksoud, “A numerical assessment of the heterogeneous effects of innovative shroud profiles for horizontal axis wind turbine,” Heliyon, vol. 11, no. 2, 2025.
  16. T. A. Jauhar et al., “Effect of flanged diffuser divergence angle on wind turbine: A numerical investigation,” PLoS ONE, vol. 18, no. 6, 2023.
  17. M. R. Behery, D. H. Didane, and B. Manshoor, “Optimization of flanged diffuser for small-scale wind power applications,” CFD Letters, vol. 16, no. 7, pp. 54–70, 2024.
  18. A. Rachman, A. Johnstone, and B. Kosasih, “The effects of shape and size on duct-augmented horizontal axis turbine performance,” Wind Engineering, vol. 45, no. 4, pp. 953–972, 2021.
  19. Y. Nakayama, “Fundamentals of flow,” in Introduction to Fluid Mechanics. Oxford, U.K.: Butterworth-Heinemann, 2018, pp. 51–65.
  20. F. R. Menter, “Two-equation eddy-viscosity turbulence models for engineering applications,” AIAA Journal, vol. 32, no. 8, pp. 1598–1605, 1994.